High Speed Revolution 40,000 RPM Motor – Long Shaft

GUARDER High Speed Revolution Long-Shaft Motor
The long shaft is primarily suitable for V2 gearboxes used in M4 / M16, MP5, G3, SCAR and other structurally compatible AEGs. The motor features powerful magnets, ball bearings, durable carbon brushes and a Type O steel pinion. To make optimal use of its 40,000 rpm speed, we recommend approximately M90–M110 springs; for significantly stronger springs, a High Torque motor is more suitable. In a high-speed setup, the entire drive system is important, not just the motor itself. In practice, we therefore recommend paying attention to correct gear shimming, motor height adjustment, the condition of the pinion and bevel gear, as well as a suitable electronic unit (MOSFET or ETU). Final RoF always also depends on the gear ratio, spring, battery and overall gearbox tuning.
Key Features

High-Speed Design
The motor is designed for high speeds of 40,000 rpm and increased AEG RoF. It is therefore particularly suitable for setups where cycle speed is more important than high torque.

For M90–M110 Springs
It is best suited for low- to medium-strength M90–M110 springs. For significantly stronger springs, we recommend choosing a High Torque motor.

Long Shaft
The Long Type design is intended primarily for V2 gearboxes and is commonly used in M4 / M16, MP5, G3, SCAR and other compatible AEG platforms.

Durable Internal Design
The motor uses powerful magnets, ball bearings and durable carbon brushes to support smooth operation at high speeds.

Type O Steel Pinion
The Type O steel pinion transfers motor power to the bevel gear. During installation, we recommend carefully adjusting the motor height to ensure correct engagement between the two gears.

Technical Specifications

Type: High..