Name: V2 Lightning ETU Unit – Front Wiring
Brand: Perun
SKU: PERUN026

V2 Lightning ETU Unit – Front Wiring

Important Notes After use, always disconnect the battery, the unit draws a small standby current. Do not use batteries above 17 V, permanent damage may occur. After using pre-cocking, release the spring by switching to SEMI and holding the trigger for approx. 3 seconds. During installation, ensure proper wire routing to prevent damage when assembling the rifle. Package Contents Perun V2 Lightning ETU unit Front wiring with T-Deans connector (pre-installed on the unit) Install...

Ti serve anche

Descrizione del prodotto

Important Notes

After use, always disconnect the battery, the unit draws a small standby current.
Do not use batteries above 17 V, permanent damage may occur.
After using pre-cocking, release the spring by switching to SEMI and holding the trigger for approx. 3 seconds.
During installation, ensure proper wire routing to prevent damage when assembling the rifle.

Package Contents

Perun V2 Lightning ETU unit
Front wiring with T-Deans connector (pre-installed on the unit)
Installation and user manual

Specifiche

Costruzione

Materiale: ABS / Plastic
Versione gearbox: V2
MOSFET: YES

Alimentazione e caricatore

Connettore batteria: T-Dean
Batteria inclusa: NO

Generale

Variants: V2 Lighting ETU (Front)
Colore: White
Materiale corpo/receiver: ABS / Plastic
Tipo di connettore: T-Dean
Processor unit: YES
Supported voltage: 7 V – 17 V
Supported batteries: Li-Pol, Li-Ion
Supported motors: Standard brushed and brushless BLDC
Supported modules: Clicker V2, Clicker V2 PRO, Speeder V2
Programming: Via trigger and fire selector
Li-Po alarm: 3,7 V per cell
Diagnostics and protection: Short circuit, gearbox lock-up, overheating protection, external magnetic field detection, LED error indication

V2 Lightning ETU Unit – Front Wiring

Ti serve anche

Descrizione del prodotto

Important Notes

Package Contents

Specifiche

Recensioni

Altri hanno visto anche